Serebrin - Silver Water Ionizer

A simple household electronic device that allows you to quickly and easily prepare healthy and household use aqueous solutions of different concentrations of silver. To the device the manual describing methods of preparation and use of silver water in the treatment and prevention purposes and in everyday life. SEREBRIN has two modes of operation, and provides a solution with a content of silver ions in a wide range from 0.045 to 0.45 mg / l.

The basis of preparation of aqueous ionic solutions and colloidal silver is an electrolytic method - passing a direct electric current through electrodes immersed in the water. This is accompanied by anodic dissolution, ie water is saturated with ions serebra.Kontsentratsiya solution depends on the set current and the amount of water to be treated.

The device consists of two independent parts:

electronic unit
Cartridge electrodes.
E represents a block body - a fork in the side surface of which socket is situated cartridge. On the cover of the case are the power switch, the mode switch of the electric current and the light. The cartridge is configured as a "float", at the bottom of which there are electrodes. The anode is a silver plate, cathode - stainless steel plate. The cartridge is connected to the electronic unit with the connecting cable.
The cartridge is placed in a container of the dosed quantity of water.

The device is powered by a battery 23AE - 12 V. Serebrin turns on automatically when immersed in water and turns off when you remove the device from the water.
Processing time water controlled by a timer with a period of 4 seconds indicator is flashing.

Basic parameters for 2 operation mode (the processing time and constant electric current through the electrodes)

parameter name
  mode
Mode 1 Mode 2
Concentration of silver ions in the bulk 2n, mg / l 0.45 0.045
Processing Time (sec.) 30 150
Permanent e-mail. the current through the electrodes mA. August 4
The total volume of water to be treated, l (to generate the average resource) 13,000 1,300
Average cartridge hour. 60 30
Note:

Concentration of the solution is inversely proportional to the volume of water used. For example, to reduce the concentration of the solution twice use twice the original water or halve the processing time.
As source can be used pure tap water, natural water sources, the filtered water with a salinity of at least 100 mg / l.
When using water with a salinity of less than 100 mg / l in water, add sodium soli.Rastvorit in one cup of water and a teaspoon of salt per liter of treated water is to add 0.5 teaspoon resulting solution.
The resulting silver ion solution thoroughly mixed for 0.5-1 min.
As drinking water solution can be used with the maximum concentration of silver ions is not more than 0.05 mg / l.
Solutions with a concentration of 0.05 mg silver / liter used in accordance with instructions for use.
The solution was stored in an opaque glass container in a dark place. Shelf life of the solution to the "drinking" concentration (0.05 mg / L) for 30 days.
operation

Pour into a container in a selected volume of water (see. Table. 1).
Insert the plug into the socket 2 cartridge electronic module 1.
Lower the cartridge into the water 2.
Plug the electronic unit 1 into an electrical outlet.
Set the required operating mode switch 4. Press 4 up 1 mode is activated, pressing down 4, the mode 2.
Connect the unit switch 3 at the same time to enable the network indicator. Withstand the required processing time water
At the end of the water treatment unit to turn off a switch 3, the light goes out.
Appearance of the device in good working order

1 - electronic unit
2 - cartridge with electrodes
3 - switch network
4 - mode switch
5 - LED

   Table 1

volume
treated water
  The concentration of silver ions mg / l
   Mode1 (30 sec.) Mode 2 (150 seconds)
  2 0.045 0.45 L
  0.2 L 0.45 4.5
  L 20 0.045 0.0045
ATTENTION. If water containing silver ions to boil, silver is partially reduced and turns into a physiologically inactive form.

MAINTENANCE.

Dark coating on the electrodes can be wiped with a cotton swab dipped in liquid ammonia.
Changes in the color of the electrode does not affect the operation of the apparatus.
WARRANTY.

Guarantee period is 12 months from the date of sale, subject to customer requirements of this instruction manual.
The company undertakes within the warranty period, to repair the appliance free of the failed through the fault of the manufacturer.
The manufacturer's warranty does not cover devices with mechanical damage and traces of heat.